HIGH STRAIN DYNAMIC LOAD TESTING AND PILE DRIVING MONITORING SYSTEM
The Pile Driving Analyzer® (PDA) system is the most widely employed system for Dynamic Load Testing and Pile Driving
The Pile Dynamics Analyzer – Dynamic Load Tester was designed specifically for quality assurance testing of drilled shafts and bored piles. The PDA-DLT allows for multiple configurations of force measurement. The system acquires data from accelerometers
CAPWAP® (Case Pile Wave Analysis Program) is a software program that estimates total bearing capacity of a pile or shaft, as well as resistance distribution along the shaft and at the toe. The program takes as input the force and velocity
GRLWEAP is a one-dimensional Wave Equation Analysis program that simulates the pile response to pile driving equipment.
GRLWEAP predicts driving stresses, hammer performance
The Pile Integrity Tester (PIT) gives peace of mind that a pile or shaft is free of major cracks and voids, prior to construction of the superstructure. It may be used on most concrete or wood foundations. The PIT may also be used to test piles integral
Thermal Integrity Profiler (TIP) evaluation of the entire cross-section and the entire length of the deep foundation element measuring heat generated by curing cement to assess the quality of drilled shafts/bored piles, augered cast in place
The PIR is an Automated Monitoring Equipment that assists in the correct installation of augered cast in place (ACIP) / continuous flight auger (CFA) and drilled displacement piles by displaying target versus actual poured concrete volume in real time.
SHAPE is a cost effective QA testing device providing a visual representation of foundation excavation prior to concrete pour in wet conditions
The SPT Analyzer measures the energy transferred into an instrumented SPT rod during a Standard Penetration Test (SPT). This permits the adjustment of the measured N-value to the normalized N60 for standard 60% energy transfer into the rods
SQUID new technology for quantitative, real-time assessment of the cleanliness and competency of the bottom surface of bored pile or drilled shaft foundations
E-Sax is a handheld instrument registering relevant pile driving parameters, calculating diesel hammer stroke or hammer blows per minute (BPM), for an accurate pile driving log.
Champ-Q evaluation of concrete quality in deep foundations by the Crosshole Sonic Logging method (CSL)
TEMP (Thermal Evaluation of Mass Pours) is a system that measures temperatures in various points of a mass concrete pour, as the curing cement generates heat. Allows for remote notifications via Short Message Service (SMS).
PDI-TOMO is a 3D tomography imaging tool that supplements the CHAMP output. It analyzes wave speeds (derived from arrival time data from the scans of all pairs of tubes) to yield a wave speed map of the entire shaft volume.
Length Inductive Test Equipment (LITE) evaluates the length of existing steel piles (Steel Sheet Piles, H-piles, Pipe piles, Cased Drilled Shafts, and highly reinforced Drilled Shafts) using the inductive field method.